PVC PPR PB PVDF HDPR Plastic Pipe Welding Tools Hotmelt Socket Fusion

• We have 100% inspection to strictly control the quality of the thermostat.
• It has double tube design, can has fast heating, saving time and effort.
• Thicken panel can store heat and improve work efficiency.
• Anti-scalding non-slip handle.
• Iron box packaging, durable and not deformed.
• Support OEM brand customization.
• Has heating indicator.
• Black gold die head, not easy to stick to the tube.
• Dual temperature and dual control can speed efficiency.
• X-shaped bracket, enhanced load-bearing effect, stable work.
• The front-end independent die head easily solves the corner takeover.

Using 

Place the machine on the support board well. Install corresponding matrixes according to specifications needed. Tight matrixes with wrench, smaller sizes in front generally.

Turn on power (Caution: power supply must be earthed). Green indicate or shows the machine is heating; red indicator or shows the machine has stopped heating and it is time for work.

Cut the pipe. Push the pipe or fitting into matrix for some time (see the table), pull them out rapidly and then insert, not screw to the depth needed steadily.

• Note: If it is under 5℃, 50% more heating time is needed. 

Installation
I. Cuttings
1. Cut the pipe right angle to its axis using burr free cutter.
2. Ensure that pipes is free from burrs or cutting chip
3. Clean the pipe & fitting perfectly before welding
4. Mark welding depth at the end of pipes.

II. Heating
1. Mount the suitable dies on heating element of welding machine according to the diameter of Pipe and fitting to be welded
2. Connect the welding machine to 220/230 volts A.C. power supply.
3Select 260 Deg. C. temperature on the welding machine thermostat.
4. Wait for reaching the required working temperature
5. Insert the pipe and the fitting in the dies by exerting light pressure.
6. For heating time, refer the table below for different sizes of Pipes.

III. Welding
1. After heating, quickly insert pipe into the fitting by exerting light pressure.
2. Any misalignment should be corrected immediately after insertion to avoid any Stress in the weld
3. Allow the joint to cool as per cooling time given in table.

Caution 

Please check the outer cover and cables of the machine first. Don’t use it if it is damaged.

The power supply must be earthed.

Water & various of kinds of liquid is prevented from entering the machine. It is prohibited to us outside on rainy days.

Keep tinder far away. 

Operators are strongly suggested to wear gloves when working.

For the safety and good performance of the device, only professionals are allowed to open the machine or adjust temperature.

If indicators don’t change for long, it means the device is in unnormal working state, stop your work and turn off the power immediately.

Turn the machine to manufacturer of professionals for repair when it is out of work.

Other size in option